Config¶

config 'qmp' 'interfaces'

1. option 'configure_switch' 'eth0' # (uncomment line if available, e.g. WGT634U)
   option 'lan_devices' 'eth0 wlan1 dummy0' # will be used as is!
   option 'wan_devices' 'eth1' # will be used as is!
   option 'mesh_devices' 'wlan0 wlan2 eth0 eth1' # will be extended by vlan tag!

config 'qmp' 'node'
option 'primary_device' 'eth0'
option 'community_id' 'qMp'
option 'community_node_id' ''
option 'key' '/tmp/qmp_key'

config 'qmp' 'update'
option 'url' 'http://fw.qmp.cat/testing'
option 'images' 'IMAGES'
option 'devices' 'DEVICES'
option 'filter' 'sysupgrade'
option 'preserve' '/etc/config/qmp /etc/shadow /etc/passwd /etc/rc.local /etc/firewall.user /etc/dropbear/* /etc/config/b6m-spread'

config 'qmp' 'non_overlapping'
option 'ignore' '0' # Each node assings a non-overlapping DHCP IPv4 ranges over a /16 network on lan device
option 'dhcp_offset' '2'
option 'qmp_leasetime' '1h'

config 'qmp' 'networks'
option 'dns' '141.1.1.1 85.126.4.170 202.83.95.227'
option 'lan_address' '172.30.22.1'
option 'lan_netmask' '255.255.255.0'
#option 'publish_lan' '0'
#option 'niit_prefix96' '0:0:0:0:0:ffff' # omit trailing 32 ipv4 bits !
option 'mesh_protocol_vids' 'olsr6:1 bmx6:2' # means olsr6 use vlantag 10+1, bmx6 use vlantag 10+2
option 'mesh_vid_offset' '10'

1. option 'olsr6_ipv4_address' '10.201.9.01'
2. option 'olsr6_ipv4_netmask' '255.255.255.0'
3. option 'olsr6_6to4_netmask' '120'
4. option 'bmx6_ipv4_address' '10.202.9.01/24' # if commented out then option is autoconfigured based on # community_node_id and bmx6_ipv4_prefix
   option 'bmx6_tablePrefTuns' '7000'
   option 'bmx6_tableTuns' '70'
   option 'bmx6_throwRules' '1'

option 'babel_mesh_prefix48' 'fd03:0:0'
    option 'netserver' '1'

config 'qmp' 'tunnels'
option 'search_ipv4_tunnel' '0.0.0.0/0'
option 'search_ipv6_tunnel' '::/0'

1. option 'offer_ipv4_tunnel' '0.0.0.0/0'
2. option 'offer_ipv6_tunnel' '::/0'

config 'qmp' 'wireless'
option 'driver' 'mac80211'
option 'country' 'SP'
option 'bssid' '02:CA:FF:EE:BA:BE'