qmpfw: Quick Mesh Project legacy firmware generator (deprecated)

=================================================================================
qMpfw SDK
=================================================================================

qMpfw is a tool for developers to create a development enviroment for qMp.
Basically it consists in one Makefile, so it is called using "make" command.

Read Only URL: http://qmp.cat/git/qmpfw.git
Developer URL: ssh://gitosis@qmp.cat:221/qmpfw.git

=================================================================================
Command options
=================================================================================

To compile a qMp image from scratch, you need to specify the target (next example with target=rspro):
This command will run all necessary commands to compile the image. After the compilation you can see the
OpenWRT code in directory: build/[target]

make T=rspro build

Also you can specify the number of parallel processes for compilation and the verbose level:

make V=99 J=2 T=rspro build

For work in developer mode (uses QMP readwrite repository instead readonly one)

make T=rspro DEV=1 build

---------------------------------------------------------------------------------
To see list of avaiable targets run:

make list_targets

---------------------------------------------------------------------------------
This will update all targets

make update

Note that this will update only qmp and b6m source (not openwrt)

---------------------------------------------------------------------------------
This will update only rspro target

make T=rspro update

---------------------------------------------------------------------------------
This will update all sources (qmp, openwrt feeds and eighennet)

make update_all

---------------------------------------------------------------------------------
To syncronize config files from configs/ dir to existing target

make T=rspro sync_config

---------------------------------------------------------------------------------
To run menuconfig (from openwrt):

make T=rspro menuconfig

After that, the new config file will be applied to destination target and also it will by copied inside build/configs directory

---------------------------------------------------------------------------------
To run kernel menuconfig (from openwrt), in this case config file will be not copied because it is not directly compatible with configs/target/kernel_config:

make T=rspro kernel_menuconfig

---------------------------------------------------------------------------------
To run the initial checkout:

make T=rspro checkout

---------------------------------------------------------------------------------
Copy images built before to output directory

make T=rspro post_build

---------------------------------------------------------------------------------
To clean specific target:

make T=rspro clean

---------------------------------------------------------------------------------
To clean all targets:

make clean

---------------------------------------------------------------------------------
To clean just qmp packages from a target

make T=rspro clean_qmp

---------------------------------------------------------------------------------
To configure some general parameters from qMp you can run:

make config

TODO: This feature is missing


=================================================================================
Directory structure
=================================================================================

There are several directories and files. This is the functionallity for each of them:

- Makefile: the main makefile

- targets.mk: file which contains all information related with targets. If you want to add a new supported device you must edit it

- build: here you will have all needed sources

- build/configs: if you do some change in config file using "menuconfig" option, the new config is placed here (and also in destination target)

- dl: download folder for OpenWRT packages

- configs: config files for each kind of hardware. These are the default ones provided by qmpfw

- images: output directory for compiled images, each of them has a different timestamp, so you can have as many as you want

- files: directories and files inside will be directly copied to the root of the system image