Projecte

General

Perfil

Temps invertit

Filtres

Aplicar Netejar

Hores: 1677:45

Data Usuari Activitat Assumpte Comentari Hores
13-02-2013 Simó Albert i Beltran Disseny Error #203: eth1 only mesh fails Test the solution. 0:30 Actions
12-02-2013 Simó Albert i Beltran Disseny Error #203: eth1 only mesh fails Test problem with attitude_adjustment branch. 1:00 Actions
04-04-2012 Axel Neumann Disseny Error #117: BMX6 don't support non alphanumeric characters in hostname acceptable for now 1:00 Actions
01-06-2011 Simó Albert i Beltran Disseny Característica #33: Create a dynamic and decentralized BMX6 map. Implemented a proof of concept: http://gsf.guifi.net/gsf/map-dyn, see #59. 67:00 Actions
01-12-2020 Roger Pueyo Centelles Desenvolupament Error #484: Switched Ethernet devices with all ports in one VLAN are not correctly handled during autoconfiguration Race condition 4:00 Actions
04-07-2020 Roger Pueyo Centelles Desenvolupament Característica #482: primary_device on devices with DSA networking Still eth0 is there, though 1:00 Actions
07-07-2020 Roger Pueyo Centelles Desenvolupament Error #481: LAN bridge consistently gets 169.254.185.1 address during qmp_autoconf ubus reports it better and on time 2:00 Actions
04-07-2020 Roger Pueyo Centelles Desenvolupament Error #481: LAN bridge consistently gets 169.254.185.1 address during qmp_autoconf Caused by the 2.4 GHz radio being in adhoc/11s mesh and AP? 1:00 Actions
11-12-2019 Roger Pueyo Centelles Desenvolupament Error #475: /usr/lib/lua/luci/dispatcher.lua:756: module 'luci.cbi' not found: Fixed with package luci-compat 1:00 Actions
21-02-2020 Roger Pueyo Centelles Desenvolupament Error #474: Custom community names are not included into the hostname 4:00 Actions
21-02-2020 Roger Pueyo Centelles Desenvolupament Error #474: Custom community names are not included into the hostname Decisions 1:00 Actions
08-12-2018 Roger Pueyo Centelles Desenvolupament Característica #470: Check WiFi status when using 802.11s on DFS-enforced channels Script ready 4:00 Actions
03-10-2018 Roger Pueyo Centelles Desenvolupament Error #466: Devices with a switch on eth0 and eth0.1 eth0.2 interfaces on top of it are not properly autoconfigured Fixed 3:00 Actions
25-09-2018 Roger Pueyo Centelles Desenvolupament Error #463: When dual wifi mode (e.g.: 802.11s + adhoc) is used, wlan0 and wlan0a are shown in Easy Setup Fixed 3:00 Actions
20-02-2020 Roger Pueyo Centelles Desenvolupament Característica #461: Allow choosing wireless country Added 2:00 Actions
17-09-2018 Roger Pueyo Centelles Desenvolupament Error #460: qMp autoconfiguration script does not autoconfigure the wireless interfaces Not reproducible (II) 1:00 Actions
17-09-2018 Roger Pueyo Centelles Desenvolupament Error #460: qMp autoconfiguration script does not autoconfigure the wireless interfaces Not reproducible 1:00 Actions
28-08-2018 Roger Pueyo Centelles Desenvolupament Característica #457: [nc-gui] All the "debug" options are shown in the menu 4:00 Actions
28-08-2018 Roger Pueyo Centelles Desenvolupament Error #450: [qmp-ncgui] nodes[indexNode(nodeId)].system.board.release.codename does not exist anymore 1:00 Actions
06-02-2019 Roger Pueyo Centelles Desenvolupament Error #446: [qmp-users] BMX6 Graph issue in Macondo Fixed upstream 7:00 Actions
19-07-2018 Roger Pueyo Centelles Desenvolupament Error #446: [qmp-users] BMX6 Graph issue in Macondo Also depends on BMX6 bug 2:00 Actions
25-01-2018 Roger Pueyo Centelles Desenvolupament Error #443: Can't IPv4 ping between nodes in qMp 4.0 Macondo Depends on BMX6 version 1:00 Actions
25-01-2018 Roger Pueyo Centelles Desenvolupament Error #443: Can't IPv4 ping between nodes in qMp 4.0 Macondo Depends on BMX6 version 1:00 Actions
16-01-2018 Roger Pueyo Centelles Desenvolupament Suport #441: root password overwritten on first boot (or after flashing) Check file /qmp_configured 0:12 Actions
25-10-2017 Roger Pueyo Centelles Desenvolupament Error #430: Reconfigure buttons in "Wireless settings" do not really work as expected Removed duplicate button and fixed submit actions 2:00 Actions
25-10-2017 Roger Pueyo Centelles Desenvolupament Error #429: A wireless device configured as "ignored" by qMp can not be reconfigured again Won't fix 2:00 Actions
23-10-2017 Roger Pueyo Centelles Desenvolupament Error #429: A wireless device configured as "ignored" by qMp can not be reconfigured again Interfaces can be reconfigured in wireless section, in two steps 2:00 Actions
25-10-2017 Roger Pueyo Centelles Desenvolupament Característica #427: "Use mesh in all wired devices" (meshall) option in east setup is not saved anywhere in qMp config Removed option 1:00 Actions
24-04-2021 Roger Pueyo Centelles Desenvolupament Error #423: Devices with a single Ethernet interface and a swith driving different ports (e.g. eth0=> eth0.1+eth0.2) are not properly managed if the switch is on eth1 instead of eth0 (case of TL-WR841N-v8) Fixed 10:00 Actions
07-02-2019 Roger Pueyo Centelles Desenvolupament Error #423: Devices with a single Ethernet interface and a swith driving different ports (e.g. eth0=> eth0.1+eth0.2) are not properly managed if the switch is on eth1 instead of eth0 (case of TL-WR841N-v8) Use the device's own info to properly decide how to manage interfaces. 1:00 Actions
04-04-2017 Roger Pueyo Centelles Desenvolupament Error #414: Wired network interfaces not shown on the web GUI for devices without switch (i.e. eth0), while switched ones do (e.g. eth0.2) Fixed 2:00 Actions
16-09-2018 Roger Pueyo Centelles Desenvolupament Característica #394: Proper detection and autoconfiguration of wireless interfaces Should already work quite well 8:00 Actions
18-03-2017 Roger Pueyo Centelles Desenvolupament Error #393: Asymetric BMX6 link on ethernet bridge interface Interface roles assignation has been reworked 8:00 Actions
07-08-2015 Roger Pueyo Centelles Desenvolupament Error #377: Network configuration is not really applied after "Saving and applying" settings and a manual reboot is needed to have it working Seems to be working 8:00 Actions
04-08-2015 Roger Pueyo Centelles Desenvolupament Error #377: Network configuration is not really applied after "Saving and applying" settings and a manual reboot is needed to have it working Backported QinQ 8:00 Actions
08-07-2015 Roger Pueyo Centelles Desenvolupament Error #372: [Clearance 3.2-rc2] No BMX6 frames in Ethernet interface for Ubiquiti's Nanobeam 1:00 Actions
05-07-2015 Roger Pueyo Centelles Desenvolupament Error #361: TL WR-842ND-v2: The default flash has wan and lan swapped. Device hook created 1:00 Actions
07-08-2015 Roger Pueyo Centelles Desenvolupament Error #356: [Kalimotxo] libremap-agent crashes (missing luci.fs) Patch accepted 4:00 Actions
27-02-2015 Roger Pueyo Centelles Desenvolupament Característica #349: [Clearance 3.1] Backporting iperf3 Backported in NC's feed 2:00 Actions
07-08-2015 Roger Pueyo Centelles Desenvolupament Error #344: [Kalimotxo] WRTNode network settings Fixed 2:00 Actions
25-10-2017 Roger Pueyo Centelles Desenvolupament Característica #343: Include by default luci-app-qos in Alix and/or x86, it works Fixed 1:00 Actions
23-01-2015 Roger Pueyo Centelles Desenvolupament Error #342: [kalimotxo] Web interface is not working Emergency fix 0:24 Actions
21-02-2020 Roger Pueyo Centelles Desenvolupament Característica #339: add the number of nodes in the network Moved to luci-app-bmx6 1:00 Actions
19-06-2015 Roger Pueyo Centelles Desenvolupament Design #337: 5GHz 40 MHz channel bandwidth (HT40) Fixed 2:00 Actions
05-07-2015 Roger Pueyo Centelles Desenvolupament Error #331: [TL-WDR4900] [Kalimotxo/Clearance] Error while using _qmpcontrol upgrade_ New hash calculation method is brilliant! 4:00 Actions
21-12-2014 Roger Pueyo Centelles Desenvolupament Error #331: [TL-WDR4900] [Kalimotxo/Clearance] Error while using _qmpcontrol upgrade_ Fixed 2:00 Actions
04-12-2014 Roger Pueyo Centelles Desenvolupament Característica #327: Add "qMp %version %codename" to OpenWrt Firmware Version Modified Makefile in qmpfw 2:30 Actions
27-05-2015 Roger Pueyo Centelles Desenvolupament Característica #318: Enable 5/10 MHz bandwidth for whitespaces Does not apply 0:01 Actions
07-08-2015 Roger Pueyo Centelles Desenvolupament Suport #315: [Kalimotxo] VLAN_12 is not created in eth0 (blue port) on TP-Link TL-WR841N-v8 Fixed in new interfaces management scripts 2:00 Actions
07-08-2015 Roger Pueyo Centelles Desenvolupament Error #312: bmx6/qMp crashed, why? (attached files)man This is a BMX6-related issue 1:00 Actions
(1-50/304) Per pàgina: 25, 50, 100

També disponible a: Atom CSV